Barudan BEVT Elite Pro II 15-Thread Embroidery Machine

BEVT Elite Pro II 15-Thread Embroidery Machine

Description

Barudan single head machine, relatively simple for a professional system. Able to sew flats, caps and tubular goods.

Classes

TBW

Specifications

• LCD screen
• Radius Cylinder Arm
• Large Field Size
• 10 million stich capacity in 30 patters
• CF Card slot
• Standby function
• Automatic detection of top and bobbin thread breaks
• Embroidery Area: 330X500MM
• Cap Frame: 79x360mm
• Frames Max: 330x438mm
• Needles: 15
• Stitch Length: .1~12.7mm
• Speed: 1300

• Electrical spec:

VOLT AC 100-240 V

WATT 0.5 KW

PHASE 1P   50/60 HZ

MN Asset Details

File:Serialnumberplate.jpg

toolname Serial Number Plate

• Location: where
• Model Number: BEVT-Z1501 CBII
• Serial Number: 3117897G13
• MN Asset Number: mnAN

Safety Specifics

All general MN Safety policies of course apply to use of this tool, as do safety policies for the containing shop area and safety practices prescribed in our classes and/or in detailed tool documentation, regardless of whether they're repeated here.

Embroidery Safety

• Operate only from the front. Do not load work to the machine from the back side.
• Do not operate without the protective covers for the shaft, pulley belt and gear in place.
• No long necklaces, bracelets near the working machine.
• One person at a time should work the machine.

For any sewing machine:

1. Keep your eye on the needle while sewing.
2. Keep your fingers away from all moving parts. Do not touch handwheel, thread takeup levers, needles etc.
3. Do not let anything obstruct the moving parts: foot pedals, levers, needles, etc.
4. Use care when pushing or pulling fabric when sewing so you do not deflect the needle and cause it to break. Broken needles fly unpredictably and may travel long distances.
5. Remove pins before the machine sews over them. They blunt or dull the needle and can causing timing problems.
6. Make sure the needle isn't moving, is at it's highest point, and the take-up lever is up before you remove fabric to avoid needle deflection.
7. Avoid loose clothing or long sleeves that might get caught in the work.
8. If a needle becomes bent or breaks, report it.
9. Turn off the power switch when:
   1. Operation is complete
   2. Replacing or removing the needle or presser foot
   3. Leaving the machine unattended
10. Turn off the power switch and unplug the cord for these situations:
    1. Power failure during use
    2. Servicing the machine

All general MN Safety policies of course apply to use of this tool, as do safety policies for the containing shop area and safety practices prescribed in our classes and/or in detailed tool documentation, regardless of whether they're repeated here.

Documentation

Instruction Manual

Lubrication Instructions

Parts List

Materials, Tooling, Accessories

TBW

Settings

TBW

Software

TBW

Tips & Tricks

TBW

Back to MN-S Textiles Equipment List