Woodshops

This page is about general woodworking tools and tips. For the wood shop at the Maker Nexus makerspace in Sunnyvale, CA, see MN-Woodshop.

Materials

Wood

Of course, wood! Check out the Wood Database for tons of information about different woods. Identification, strength, finishes, etc.

Glues

Are end grain glue joints weak? No! See the short, very interesting test video.

Some local knowledge from our members.

Finishes

• Odie's Oil
  • Wipe on, dry, wipe off. 2 coats usually good. Generally easy to apply.
  • For larger endgrain slabs, recommendation is to use thin coat and allow 1-2 days per coat to dry completely.
  • Cookie slabs can retain a lot of moisture and that will interfere with the hardening process.
• Tung oil finishes

Supplies

Also see the general Supply Sources page.

Tools

Bench Vise

• How to pick a vise? A fun video with serious information

Wood Lathe

• Using a skew. Nice video explaining skew angles and when to use each.

Wood Chisels

• Sharpening: The grind on DeWalt chisels is very rough out of the box. The edge isn't durable because it is very jagged. To get a good edge on them you need to carefully flatten the surface of the bevel of the chisel with a rough sharpening stone before moving on to finer grits. Sandpaper is not the right tool for the job.

Tips

Basic Tips

• The Way Wood Works -- What Every Woodworker Needs to Know About Wood
• Matt Estlea

Wood Inlay

• How to create dramatic inlays with epoxy
• $15,000 Kitchen Island. Good tips on the overall process of a wood countertop, including epoxy inlay.

Edge Treatment

• Making Edge-Grain Patterned Plywood. The link drops you to the finished piece, the whole video shows how he did it.

Sanding

• So, you think you know how to sand, eh?. Learn to sand correctly.
• Drum sander tips

Table Saw

• General intro to table saw safety
• Blade Height - what is the right height for your cut?
• Tablesaw set up - excellent tips on safety that you might not know about.
• Kickback and how to avoid it. Work safely!
• A different kind of kickback!
• Three different blades - why to use each
• Jointer, Planer, Drum sander - what do they each do and why?
• Half laps on the tablesaw without a dado set

Router

• Which direction to move the router?

Drilling

• Forstner bits and how to use them

Turning

• Richard Raffan
• Tomislav Tomasic Woodturning (Dodir Drva)

Misc

• An analysis of Parallel clamps
• Tips on precision work with our tools

Safety

• Showing how tablesaw accidents can happen.